1984 Union Cutter11m

You can board Karen Marie through life-line gates to port or starboard. She has good access to the forward decks with wide side decks and protective bullworks and life-lines. The cockpit is open and large enough for four to sit comfortably. There is a rebuilt helm-seat at the beautiful teak binakle which holds a "Heritage Skylight" brass compass. All the teak is in excellent condition. Below deck the main cabin is accessed from the cockpit through the companionway down 4 steps.

To starboard is a large chart table with drawers and a cabinet. VHF radio, chart plotter and electrical switches are all in reach. There is a roomy quarter-berth aft of this, with access to the engine compartment.

To port is a very functional galley with a 3 burner stove + oven, a large 2 bin basin with 2 bronze faucets and plenty of storage in beautifully ornate cabinetry.

Forward of the Galley the salon has a large U-shape setee with dining table to port and a pull-out sofa/bed to starboard. Much of the wood work is custom and beautifully crafted. Above the table is a brass lamp and a raised "Butter-Fly" hatch. There are six opening ports in the main cabin.

Entering the forward cabin there is a foyer with a hatch over head, a hanging locker to starboard, below an opening port, and the head is to port. The cleverly designed doors expand the head to include the foyer upon opening for a large private head and shower. The V-berth, forward is comfortable for 2 and has plenty of storage. There is ventilation from the overhead hatch.

• The bowsprit was recently removed for inspection and sanded down to wood. it is made of solid teak and after 30+ years, was in perfect shape. It was finished with 3 coats of West System Epoxy, followed by 3 coats of Interlux 2 part Polyurethane.
• The Simpson Laurence manual windlass has been re-packed with marine twice since new and re-painted. The platform was reconstructed from thick aluminum plate on Starboard composite and secured with stainless bolts and backing plate. A second haus pipe was added.
• In 2008 the original screw-down decks were removed, all screw holes were opened and filled with epoxy, left to dry for 6 months then resurfaced with epoxy and 3/8" solid teak. The remaining outside cabin and deck areas were painted with 2 part Interlux epoxy paint.
• The forward Deck box has been rebuilt with teak. the inside has 3 coats of epoxy and is set up to hold a 10 gallon propane tank.
• All four dorades were re-chromed
• The forward and "butterfly hatches have new acrylic lenses and custom covers.
• The companionway hatch was rebuilt with epoxy coated marine ply-wood covered with teak slats. The teak slats in the cockpit were all replaced using the "West System".
• A traditional varnished teak spoke wheel and recently up-graded Edson worm drive make up the steering system.
• Aft of the helm-seat is custom made teak propane box with a 10lb. horizontal tank above the aft chain-locker. The chain-locker was rebuilt for easy access from inside.
• On the taffrail there is a teak flag-pole and mount and a custom teak and Starboard motor mount.

• The mast is deck stepped and all spars are aluminum. Built by Kemp spars which was purchased by Selden located in Charleston, South Carolina. The mast was fitted with "Strong Track" system from Tide Marine. The mainsail had full battens added and new luff hardware. The stay sail and Yankee jib are hank on and store in place for easy hoisting. All the sails are original and have been well protected and professionally maintained.
• The standing rigging was replaced with stainless wire and swage terminals. The original stainless turnbuckles, manufactured by Hasselforth Co. in Sweden remain.
• The running rigging including sheets, halyards and teak blocks have been re-built or replaced recently and are in great shape.
• The jib-track was removed, cleaned and replaced with new fasteners, the jib-sheet winches were re-chromed and re-bedded and the mainsheet traveler was replaced with Harken system.
• The life-lines and hardware have recently been replaced.

• 2 Authentic CQR 45 lb anchors sit on the bowsprit anchor rollers with 20' of new 3/8" chain and 200' of 3/4' rope rode each, plus 2 additional sets of heavy weather 1" rope rode with 20' 3/8" chain.
• 2 Danforth fluke anchors one on the stern and one on a stanchion mount forward.
• Dock lines and fenders are included.
• There are 3 USCG approved fire extinguishers
• 2 Heavy duty offshore safety harnesses
• 6+ USCG approved life jackets (New in storage bag)
• Required and recommended hand-held flares and smoke signals
• First aid kit
• Life Sling man overboard recovery system with new cover and line.
• Portable signal horn
• Radar reflector
• Binoculars
• Ring buoy type IV throwable device.

• The Main cabin headliner was replaced with new Vinyl covering with teak trim. All the through-bolts have custom teak covers.
• The Galley, to port, features a large ice box that opens from top and plenty of storage in numerous cabinets and lockers. The original Shipmate 3 burner stove with oven is mounted on gimbals and is in excellent condition. There are 2 traditional brass or bronze fixtures, one for pressurized fresh water, and one hand pump for seawater. In addition there is a fresh water foot pump and small tap.
• The chart table to starboard is large enough to lay out charts for navigation and provides plenty of storage in 2 full width drawers and a cabinet with sliding door which houses the new Xantrex 20 amp charger.
• The quarter berth which sits aft of the chart table is large enough for comfortable sleeping and has storage in cabinets along the side and underneath. An access panel was added at the foot of the berth to access the aft chain locker
• The Salon has a large U-shape Settee to port with a custom "up-down" table fabricated from repurposed teak decking. The original table is still available to convert the settee to a double berth. There is storage behind and below. To starboard is a pilot berth with new headliner and a pull-out convertible sofa/bed with storage behind and below. Behind the settee and pilot berth are custom teak-colored chainplate covers which remove for easy inspection of chainplates. The stainless steel compression post was wrapped in teak colored wood slats to add to the warm feel of the cabin. It sits on a steel base that has been kept clean dry and painted, there is access at the top for electrical connections for the mast lights and antenna. Ventilation is provided by the large "butterfly hatch and four opening ports.
• The forward cabin is made up of a convertible foyer/head to make the best use of space. There is a recently repainted wet locker to starboard with an air-pump mounted forward and an Edson "Bone Dry Emergency pump. The head to port also has new headliner and teak trim. There is a large mirror, single basin with brass fixture, a Raritan Par II marine head and a new shower assembly have never been used. All the plumbing has been recently replaced. The holding tank is located under the V-berth. It was cut open by previous owner and use for storage. A Vetus flexible tank was installed and it too has never been used.
• The V-berth is large enough for 2 adults and has custom steps fitted under the removable insert. There are teak storage lockers on each side and 2 brass reading lamps. Ventilation is provide to forward cabin by overhead hatch and opening ports.

• Karen Marie is fitted with just an Icom VHF radio and Garmin 700 series chart plotter situated inside the cabin on a custom swing arm for viewing outside the cabin.
• An extra hull transducer for connecting to the Garmin has not been installed. It should be mentioned, a reverse polarity switch has also been installed.
• Depth and speed displays are to starboard in the cockpit.
• Boston brass chronometer and barometer are located to starboard on the forward bulkhead. The barometer will require maintenance or replacement.

• Karen Marie has one 30 amp shore-power cable and receptacle. All AC outlets have been replaced with Marinco yellow marine receptacles along with necessary GFCI devices. New teak plates cover all these outlets.
• Three batteries sit in the storage space under the quarter birth. Two smaller batteries hooked up in series for the "house". These batteries total 190 amp hours. A third battery totaling 245 amp hours is set up for the engine. Batteries are all AGM. The electrical switches are set up with three separate switches; one for "house", one for the engine and the third is a parallel switch for all batteries if needed. A battery combiner has also been installed. All batteries are new as of October 2020.
• There is a 12vdc/110vac panel under the companionway and another 12v panel by the chart table. Karen Marie has adequate DC lighting when not plugged into shore power, plus cabin oil lamps give out a warm glow. A trawler oil lamp hangs over the settee along with two other bulkhead oil lamps. One is a beautiful Captain's Cabin Lamp, Dutch made and numbered with a ship motif etched on the glass globe.
• A new Xantrex battery charge is located in the cabinet below the chart table.

• The original Perkins 4-108 diesel engine and Hurth transmission have seen little use. They have approximately 2,500 hrs. and still look like new. A new marine alternator was added and the original kept as spare. All hoses and clamps have been recently replaced and the muffler was upgraded with a new Centex Vernalift water-lift muffler. The engine was regularly maintained with oil changes every 50 hrs. or five months. The drive shaft was replaced as part of general maintenance. Its connected by a Vetus flex coupling. The recently replaced bronze stuffing box with new tubing is easy to access. The engine compartment is very clean and well organized with access from inside and from the cockpit locker.
• There is a hand operated bilge pump in the cockpit locker in addition to the emergency pump in the forward wet-locker and a 12 volt Rule 3500 set up for automatic or manual operation, wired directly to the batteries.
• The fresh water pump is a PAR 36950 12 volt electric pressure pump.
• There is a portable Dometic 7000 BTU "drop-in" hatch air-conditioned new in the box.

• While the vessel was out of the water for the extensive deck replacement, the bottom was sanded down dried and coated with West System barrier coat followed by Interlux antifoul bottom paint.
• All trough-hull fittings have been replaced with bronze fittings through-bolted on 3/8" teak ply-wood with 2 coats of epoxy. The seacocks were replaced with Groco full flow bronze flanges seacocks.
• Depth and speed transducers are installed on the starboard bottom.
• A Marinco Dynaplate bonding plate was installed on the starboard side and connected to to all new 16 ga. wire throughout the vessel.
• The cutlass bearing and shaft were recently replaced the propeller is bronze 3 blade power prop. Shaft and rudder zincs were replaced every 2 years as needed most recently in 2019 and 2021.

Anchors

• 2 Authentic 45 lbs. CQR plow anchors.
• 2 Danforth fluke anchors
• 2 anchor rodes 200' x 3/4" rope plus 3/8" BBB chain lead
• 1 Heavy weather anchor rode 200' x 3/8" BBB chain lead
• 1 Extra all chain rode 200' x 3/8" BBB chain
• Dingy anchor plus rode

Cushions &Covers

• New vinyl cockpit cushions, tan
• Custom cockpit cover, Sunbrella, beige
• On deck covers for handrails, hatches, blocks and other exposed brightwork, Sunbrella, forest green
• Large Awning, Sunbrella, beige
• Fender covers, Sunbrella, gray

Deck Gear

• 2 Chrome winch handles
• 1 Bosun Chair, Heavy duty professional quality
• Beautiful custom teak boarding ladder, never used,
• International flag code set, decorative
• Fenders & dock-lines
• Outboard motor lift
• 30 amp shore power cord and 110 vac converter

Interior

• Original settee table, to convert settee to double birth
• 1 Brass trawler oil lamp
• 1 Brass Captains oil lamp with etched ship globe, Dutch made and numbered
• Other smaller oil lamps throughout the vessel

Engine spares

• Original alternator, with bracket
• Belts
• Thermostat
• Impeller
• Fuel injector
• Fuel lift pump
• Oil filters
• Fuel Filters, Perkins & Racor
• Fuel fitting with filter
• Various gaskets
• Rebuilt raw water pump
• Pencil zincs for raw water and exhaust
• Morse throttle and transmission controls, new in box

Plumbing

• Galley water filters
• Whale Gusher 10 parts & extra handle
• Fresh water pressure switch

Electronics

• Remote mike for Icom VHF
• 4 stereo speakers
• Battery monitor, never used