This classic is one of only five ever made 60 foot Mathews Cruisers and the last and only good one left in the world.
Artania II, a 1970 60’ Cruiser build by the Matthews Boat Company in Port Clinton, Ohio, is the last of the wood-hulled Matthews boats built before the company began building fiberglass boats in 1971. Formerly known as "Mahogany", the Matthews was owned by a Michigan congressman, and was a familiar sight to many cruising the Great Lakes every summer.
Artania II was purchased by her current owner at Mertaugh Boat Works during the winter of 2011. That spring some new planks were installed in time to launch for the owner to enjoy a trip to Mackinac Island as well as win 1st Place in the Les Cheneaux Antique Wooden Boat Show, the third time she would receive that honor.
During the winter layup of 2012 plans were made to replace more hull planks, and beautiful new teak decking was milled and installed while the hull planks were being replaced.The deckhouse was refurbished as well. Also a custom-designed and fabricated teak bench seat was built for the bow deck area, providing additional seating and storage. All bright work was sanded and varnished to show-quality specs, and the hull was primed and painted.
The yacht underwent a major electronics upgrade including the installation of two complete navigation systems while making extensive upgrades to the interior wiring and electrical systems onboard.
In August of 2014, Artania II headed south, and she is currently cruising the waters of South Florida
“Artania II” has just recently undergone more wood planking replacement on the underwater areas. This work has been well documented with photographs. Please request these photos if required. The company that carried out these repairs is Gillen Diesel and Marine Services at Harbour Towne Marina in Dania Beach Florida. As well as new bottom planking, a new 17.5 Kw Phasor Generator, New AGM Batteries, Mastervolt Battery Charger and Magma Energy Inverter were installed, as well as many other upgrades including some electrical upgrades. New 12 volt “gulper” bilge pumps were added to the machinery space.
There has been no expense spared in the care and upgrades to the vessel “Artania II”.
Brad Nelson 954-205-7944
Phasor 17.5kw newly installed with 20 hrs.
Receptacles: 2 x 250 volt x 50 Amp
Power cords: 1 x 250 volt x 50 Amp + 1 x 125 volt x 50 Amp
Power cords: 2 x 125 volt x 30 Amp
Battery installation: 4 x 12 Volt AGM forward to starboard in engine room
12 Volt chargers: 50 Amp “Mastervolt”
Inverter: “Magma Energy”
Inverter charger: 60 Amp
All batteries AGM sealed type in Wood boxes
Battery switches: Four approved type
Air conditioning: Cruise Air
Heating: Reverse cycle in the above + electric floor level heaters
Phone / TV recep.: Yes
Lights: 12 volt DC & 110 volt AC
Bonding system: Throughout
Engine rm. blowers: 12 volt DC
Compass: 10” Ritchie
Auto Pilot: Garmin
Radar: Garmin 7215 72 Mile
GPS: 2 x Garmin 7215
Chart plotter: In above GPS’s
VHF: Garmin VHF 200
Hailer: In VHF radio
Speed log: In GPS’s
Depth finder: Garmin GMI 10 multi
CCTV system: Yes w/ cameras in engine room, aft deck & salon
Location of galley: Forward down to port
Location of dinette: Opposite galley to starboard + helm deck table
Stove top: 4 Burner “General Electric”, electric
Microwave: “General Electric”
Convection oven: In the above microwave oven
Freezer: As above
Icemaker: On helm deck
Hot water heater: 30 gallon “Kenmore”, electric
Washer / Dryer: “Ariston” two piece
Built in system: “Kidde”
Type: 2 x 35 lb. Co2 bottles
Tank location: In engine room
Automatic release: Yes
Manual release: At helm
Hand held: 4 x 2 ½ LB. & 1 x 10 lb. Dry powder
Aux. fire pump: 12 volt deck wash downs
Dewatering pumps: 4 x 12 volt submersible type w/ float switches + 4 x 12 volt dry
out Gulper pumps
Damage Disclosure: The vessel Artania II, while docked at it's home berth in Ft. Lauderdale, lost electrical shore power and subsequently the batteries ran down and the vessel took on water, but the water level stayed below the engines. Several pumps and associated wiring was replaced and the vessel had a new 15kw Phasor generator installed, and new carpet in the aft Master Stateroom. All work was completed at Gillen Diesel and Marine Services in Dania Beach, Fl.
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Harbour Towne Marina
850 NE 3rd Street #213
Dania Beach, FL 33004